1. Achieve a target density of 650 kg fresh weight (220 kg DM)/m3 in the top 0.75 to 1.0 metre.
2. Shape the top surface convex so water drains off the bunker or pile; and the back, front, and sides of piles should not be steeper than a 1 in 3 slope.
3. Apply covering materials immediately after filling is completed.
4. A layer of oxygen barrier (OB) film and a sheet of white on black PE plastic or anti UV cover are more effective at preventing surface spoilage than single or double sheets of conventional PE plastic (see Table 8).
5. Overlap the sheets by a minimum of 1.0 to 1.5 metres. If overlap is less than 1 metre, use Silostop Silotape (Section 6) to ensure joins are airtight.
6. Arrange overlapping sheets so run-off water does not come into contact with the silage.
7. Sheets should reach 1.0 to 1.5 metres from the forage surface around the perimeter of drive-over piles.
8. Put an anti-UV cover or protective woven polypropylene netting (tarp) on top of Silostop® OB film sheets.
9. Put uniform weight on all covering materials over the entire outer surface and double or triple the weight where sheets overlap.
10. A 15 to 30 cm layer of sand and/or soil or gravel bags placed end to end is an effective way to anchor sheets around the perimeter of drive-over piles.
11. Mow the area surrounding a bunker or pile and put up temporary fencing to protect against domesticated and wild animals
12. Store weighting materials so they do not harbour vermin.
13. Inspect and repair covers frequently to minimise spoilage due to physical damage.
14. Surface spoilage has a negative effect on silage intake and digestibility, and should be discarded.